Steel 455 Deep pan by SRE

[71stage1conv]

Complete with baffle and 5/8" pickup tube. Painted and used on a dyno run only. $310 to your door in cont 48 States for current BPG members.:HI: I think it is about 7-8 qts.

Paypal welcomed...

[BrunoD]

Hi Dan,does it look stock?I am putting a motor together for a friend and I need a
deep oil pan.Can you tell me what it looks like?or show a picture of it.BrunoD.

[71stage1conv]

It is a stock pan and has the stock look, however the deep rear section doesn't look stock because it is squared off a bit. The only picture I have is on the engine some time after the dyno run. Send me you email address and you'll get the pict. I would post it here Bruno, but I would have to shrink the pict down, and I'm afraid you will not be able to see the detail.:TU:

Basically the very rear, deep part of the stock pan was cut off, then replaced with a deeper section, welded & baffled, then fit with a new longer 5/8" sump. Maybe Steve Reynolds have some good pictures. From the sides, you can only see one horizontal weld, nice job. Hey, guaranteed to meet you approval, or send it back in the same condition, no questions asked (besides, Steve got over $100 more for them + freight, before he recently stopped).

[71stage1conv]

How is this?

[BrunoD]

Dan,I'll take it.BrunoD.

[71stage1conv]

I will ship it out Monday as long as you send me your address...:ROLL: