I am a new member after recently purchasing a 64 Riviera.
The previous owner modified the rear suspension by lopping off a few inches on each end of the rear housing so as to stuff some fat tires under the back. There were no mods made to the inner housings , body, or rear frame area.
I want to put the car back to stock condition. I have located a complete rear out of a 1965 Riv. My question is, before I buy it, will it bolt directly up to the frame of my car or are they different?
I have heard that the diameters of the hub the wheel fits over may be different. Not sure if the driveshaft on a 65 uses a U-joint or a flange.... My main concern is... are the dimensions, trailing arm mount locations the same??
Thanks in advance!